Agri-Fab Mow-N-Vac 45-04072 - Manual (Page 6)

6
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(2) 3/4" Wrench
(2) 9/16" Wrench
(2) 1/2" Wrench
(2) 7/16" Wrench
(1) Screwdriver
(1) Pliers
Spray adhesive is recommended for easier
assembly!
1. Remove the hardware pack and all loose parts from the
carton. Be sure the carton is empty before discarding.
2. Lay out all the parts as shown in the carton contents.
3. Position cart body halves upright on a smooth level
surface such as a garage floor or a paved driveway. See
figure 1.
4. Assemble halves together using two 1/4" x 3/4" hex
bolts and 1/4" nylock nuts as shown in figure 1. Do not
tighten.
1/4" x 3/4" HEX BOLT
1/4" NYLOCK NUT
FIGURE 1
Do NoT leaVe THe Mow-N-Vac uNaTTeNDeD
DURING ASSEMBLY. A FALLING MOW-N-VAC
CAN CAUSE PERSONAL INJURY! PAY CLOSE
ATTENTION TO THE STABILITY OF THE MOW-
N-VAC. ASSEMBLE ON A SMOOTH, LEVEL
surFace.
CAUTION
5. Position the tailgate reinforcement bracket on outside
of cart as shown in figure 2. Assemble to the bottom of
the cart body using four 5/16" x 3/4" truss head bolts
and 5/16" nylock nuts.
Do not tighten. See figure 2.
6. Position the tailgate guides on the inside of the cart
bodies with guide channels to the front as shown in
figure 2. Assemble using four 1/4" x 3/4" hex bolts and
1/4" nylock nuts.
Do not tighten.
7. At this time, with the cart body halves pulled together,
tighten the four truss head bolts assembled in step 5
and then
tighten the four hex bolts assembled in step 6.
Do not tighten the two hex bolts that were assembled
in step 4.
8. Remove the bottom two pre-assembled bolts in the
tailgate reinforcement bracket. Assemble a 5/16" washer
and spacer onto the bolt and reassemble it to the tailgate
reinforcement bracket. See figure 3.
1/4" x 3/4"
HEX BOLT
5/16" x 3/4"
TRUSS HEAD BOLT
5/16" NYLOCK NUT
1/4" NYLOCK NUT
TAILGATE
REINFORCEMENT
BRACKET
TAILGATE GUIDE
FIGURE 2
FIGURE 3
This unit is shipped WITHOUT GASOLINE or OIL. After
assembly, see separate engine manual for proper fuel and
engine oil recommendations.
PRE-ASSEMBLED BOLT
5/16" WASHER
SPACER
TAILGATE REINFORCEMENT BRACKET