Operation – Agri-Fab Mow-N-Vac 45-04072 User Manual

Page 16

Advertising
background image

16

BEFORE STARTING

Your Vac System engine is shipped without oil or gasoline.
Service the engine with oil and gas as instructed in the
separate engine manual.

Inspect the Vac System to make sure all covers (rear
door, vinyl boot, elbow, hose adapter, hose and deck
adapter are properly attached.

Check tires for proper inflation (printed on tire).

HOW TO STOP YOUR VAC SYSTEM

To stop engine, move the throttle control lever to the
OFF position.

Disconnect spark plug wire from plug to prevent
accidental starting while equipment is unattended or
is being worked on.

WARNING: Never fill fuel tank indoors, with
the engine running, or while the engine is
hot. Do not smoke while filling tank.

CAUTION:

Alcohol blended fuels (called gasohol or using ethanol

or methanol) can attract moisture which leads to separation and
formation of acids during storage. Acidic gas can damage the fuel
system of an engine while in storage.

To avoid engine problems, the fuel system should be emptied
before storage for 30 days or longer. Drain the gas tank, start the
engine and let it run until the fuel lines and carburetor are empty.
Use fresh fuel next season. See
STORAGE Instructions for additional information.

Never use engine or carburetor cleaner products in the fuel tank
or permanent damage may occur.

CAUTION: The muffler and adjacent areas
are

hot!

LATCH LOCK LEVER Locks the cart bed down to the tongue.
Releases to allow cart to be tipped back for dumping.

BOOT Connects the plastic elbow to the fabric top, directing
discharged material into the cart.

THroTTle coNTrol Controls speed of engine.

CHOKE CONTROL Adjust to allow cold starting.

KNOW YOUR VAC SYSTEM

Read this owner's manual and safety rules before operating your Vac System.
Compare the illustration below with your Vac System to familiarize yourself with the various controls and their locations.

OPERATION

LATCH LOCK LEVER

THROTTLE
CONTROL

BOOT

CHOKE
CONTROL

Advertising