AEG AIR AND POWER STATION LA 10 - Manual (Page 22)

▪ No valve adapter required to inflate car tyres.
First remove the cap from the tyre valve.
▪
Open the quick disconnect and attach the
automotive valve plug as far as possible onto the
tyre valve. Close the valve quick disconnect
when doing so.
▪
Verify the automotive valve lever plug is firmly
attached to the tyre valve by carefully pulling on
it.
Do not operate the compressor for more
than 10 minutes. After this time allow the
unit to cool down for 10 minutes!
Automotive, motorcycle- and bicycle tyres with
automotive valve (Schrader valve with 7.7 mm
thread diameter) can be inflated without adapter!
Select the appropriate valve adapter (e.g. ).
Open the valve quick disconnect by pressing
the quick disconnect lever away from the com-
pressed air hose . Now attach the valve
adapter and press the lever toward the com-
pressed air hose to close it (see Image 5).
Check the unit and compressed air hose for
damage before every use! Do not operate dam-
aged units! Review the manufacturer instructions
for the item to be inflated before every use.
Attention! Always wear suitable ear
protectors and safety goggles during
operation!
The unit can be operated with the built-in storage
battery or the built-in 12 V vehicle plug.
4.3 Operating the compressor
▪ Set the On / Off switch to ( I ). The unit is
now operational.
▪
To turn the lighting on set the lighting On / Off
switch to ( I ).
▪
To turn the LED lights off set the light
switch to ( O ).
▪ To power the unit off set the On / Off
switch to ( O ).
4.2 Operating the lighting
Automatic start warning! If the
On / Off switch for compressor
power is set to ( I ) before switching the
unit on, the compressor will automatically start
and compressed air will be supplied to the com-
pressed air hose. Risk of property damage
and personal injury!
▪ Set the On / Off switch to ( I ). The unit is
now operational and the manometer lighting
is activated. The LED lights indicate the
current capacity of the storage battery.
▪
In operational mode the 12 V vehicle outlet
is powered.
▪
To switch the unit off set the On / Off switch
to ( O ).
4.1 Powering the unit On / Off
4.0 OPERATION /
ACCESSORIES
Image 5
13
1
20
16
19
13
15
13
13
3
7
4
4
3
22
3
4
7
97180_Luft-Energiestation_LA_10_Manual _01_08_2012_print
Mittwoch, 1. August 2012 12:30:07