AEG AIR AND POWER STATION LA 10 User Manual

Page 24

Advertising
background image

Using a pair of flat-nose pliers carefully pull the

flat fuse inside the housing unit for the controls.

Replace the defective fuse with a new 15 A flat

fuse by carefully pushing the new fuse into the
fuse holder with your thumb until it is flush with
the unit housing (see Image 9).

Image 9

Intact flat fuse
15 A (Ampere)

Fuse

Unscrew the retaining screw.

Remove the terminal cap and the 15 A

(Ampere) round fuse.

Assemble all parts with the new 15 A fuse in the

order shown and replace the retaining screw
(see Image 8).

Image 8

12 V vehicle
connector plug

Terminal cap

Round fuse 15 A (Ampere)

Retaining screw

12 V Vehicle plug

4.6 Replacing fuses

The unit's 12 V vehicle jack is now live and the
connected 12 V external device can be oper-
ated (see Image 7).

After using the external device unplug the 12 V
vehicle plug from the 12 V vehicle jack on the
unit.

Image 7

External device
12 V vehicle
plug

Remove the cover from the 12 V vehicle jack.

Connect the 12 V vehicle plug of the external

device to the unit's 12 V vehicle jack.

Set the operating switch to ( I ).

4.5 Using the 12 V vehicle outlet

Note! Do not operate the compressor or
the light whilst charging!

Connect the small round plug on the charging
mains adapter to the receptacle .

Plug the charging mains adapter into a 230 V
power socket.

Set the operating switch to ( I ). The unit will
now switch to charging mode.

The LED display will light up and the blinking
LED will indicate the current storage battery
capacity. The charging time is approx. 10 - 12
hours. The green LED must stay on when the
storage battery is fully charged.

After charging use the operating switch to
power the unit off and disconnect the 230 V
charging mains adapter from the unit and the
230 V outlet.

The storage battery should be fully charged prior
to first use.

Charging by 230 V charging mains adapter

4.4 Charging the storage battery

10

14

13

20

13

24

13

16

97180_Luft-Energiestation_LA_10_Manual _01_08_2012_print

Mittwoch, 1. August 2012 12:30:07

Advertising