AEG AIR AND POWER STATION LA 10 - Manual (Page 23)

Non-binding pressure guidelines
Automotive tyre
approx. 1.9 – 3.5 bar
Trailer tyre approx. 2.4 – 3.4 bar
Motorcycle tyre approx. 1.7 – 2.9 bar
Bicycle tyre approx. 2.0 – 4.0 bar
Football approx. 0.6 – 1.1 bar
Volleyball approx. 0.18 – 0.22 bar
Attention! Please note the manufacturer
specifications for the item. Do not use the
compressor to inflate swimming aids!
▪ Open the product's valve cover.
▪ Using the valve quick disconnect secure the
correct valve adapter and press it into the item's
valve. If the valve adapter detaches from the
valve whilst inflating, use your hand to press it
into the valve whilst inflating.
▪
Verify the valve adapter is securely connected to
the valve by carefully pulling on it.
▪
As a guide, set the arrow on the manometer
adjusting ring to the desired air pressure
value.
▪
Set the operating switch to ( I ). The unit is
now operational.
▪
To activate the compressor set the compressor
switch on the compressor to ( I ).
Note: the compressor can be switched off at any
time by setting the compressor switch or the
operating switch to ( O ).
▪
Observe and check the firmness of the item
whilst inflating. If the item has already been
overinflated, immediately interrupt the process
and switch the compressor off!
Attention! Excessive air pressure may
cause the item to burst! Risk of personal
injury and property damage!
▪
Once the air pressure marking on the adjusting
ring has been reached, use the compressor
switch to power the compressor off.
▪
Remove the valve adapter from the item's valve
and close the item's valve cap.
▪ First read the product manufacturer's instruc-
tions for inflating and the approved maximum
air pressure before inflating the product.
Do not operate the compressor for more
than 10 minutes. After this time allow the
unit to cool down for 10 minutes!
Inflating sporting goods, toys and recreational
products
▪ As a guide set the arrow marker on the mano-
meter adjusting ring to the desired air
pressure value (see Image 6).
▪ Set the On / Off switch to ( I ). The unit is
now operational.
▪ To activate the compressor set the compressor
On / Off switch to ( I ).
Note: the compressor can be switched off at
any time by setting the compressor switch
or the operating switch to ( O ).
▪ Once the air pressure marked on the ad-
justing ring has been reached, switch the com-
pressor off using the compressor switch .
To do so, set the compressor switch to ( O ).
▪ To switch off the unit the operating switch on
the unit must be switched off.
▪ Open the valve quick disconnect and remove
the auto valve connector from the tyre valve.
▪ Also check the air pressure with a second
pressure gauge to determine the accurate value.
Repeat the process if the desired air pressure
has not been reached.
▪ Then replace the valve cap on the tyre valve.
Image 6
Mark air pressure
value e.g. 2 bar
5
13
19
5
19
4
13
19
4
5
13
19
19
13
5
19
13
19
GB 23
5
97180_Luft-Energiestation_LA_10_Manual _01_08_2012_print
Mittwoch, 1. August 2012 12:30:07