AEG L99695HWD - Manual (Page 23)

The drying symbol starts to
flash.
The symbol of the set level
stays on.
The other level symbols go
off.
You cannot set all levels for all
kind of laundry.
With the timed drying:
• Press the button 5 again and again
to set the time value (see the «Drying
Programme» table).
The drying symbol comes
on.
The anti-crease symbol
comes on.
The drying time symbol
comes on.
Set time value
• Each time you press this button the
time value increases by 5 minutes.
• After some seconds the set time value
on the display changes: the appliance
calculates also the duration of the an-
ti-crease and the cooling phases.
Final time value
• Press button
6 to start the pro-
gramme. The display shows the new
time value every minute.
The drying symbol starts
to flash.
The door locked symbol
comes on.
If you set the time value of only
10 minutes, the appliance per-
forms only a cooling phase.
At the end of the programme
• The appliance stops automatically.
• The acoustic signals operate.
•
In the display comes on.
• The indicator of the Start/Pause but-
ton 6 goes off.
• The last minutes of the drying cycle
the appliance performs the anti-crease
phase.
The anti-crease symbol
flashes.
The door is still locked.
• Press button 1 to deactivate the ap-
pliance. After some minutes from the
end of the programme, the energy
saving function automatically deacti-
vates the appliance.
•
When the door locked light
goes off you can open the door.
• Remove the laundry from the appli-
ance. Make sure that the drum is emp-
ty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
11. USING THE APPLIANCE - WASHING & DRYING
11.1 NON-STOP programme -
Washing & Automatic drying
CAUTION!
Do not put a plastic device/ball
for the detergent into the
drum.
• Press button
1 to activate the appli-
ance.
• Load the laundry.
• Measure out the detergent and fabric
conditioner.
• Turn the programme dial to the wash-
ing programme. The display shows the
symbols of the different washing pha-
ses.
ENGLISH
23