AEG L98480FL - Manual (Page 16)

9. BEFORE FIRST USE
1. Put 2 litre of water in the detergent
compartment for washing phase.
This activates the drain system.
2. Put a small quantity of detergent in
the compartment for washing phase.
3. Set and start a programme for cotton
at the highest temperature without
laundry.
This removes all possible dirt from the
drum and the tub.
10. DAILY USE
WARNING!
Refer to Safety chapters.
10.1 Using weight sensors
For a correct operation of
the weight sensor, activate
the appliance and set the
programme BEFORE you
put the laundry in the drum.
10.2 Before activating the
appliance
1. Open the water tap.
2. Connect the mains plug to the mains
socket.
10.3 Activating the appliance
and setting a programme
1. Press button AutoOff to activate the
appliance.
2. Turn the programme knob to the
necessary programme.
The programme indicator comes on.
The indicator of Start/Pause button
flashes with red colour.
The display shows the default
temperature and spin and the empty
indicator bars of the available functions.
3. If it is necessary, press Temperature
button and Spin button to change
the water temperature and the spin
speed.
4. If necessary, press the related
buttons to add some functions or to
set a delayed start.
The display shows the symbol of the set
function and the digit shows the delayed
time.
10.4 Loading the laundry
1. Open the appliance door.
The display shows the maximum load for
the programme
and the weight of the
laundry .
2. Put the laundry in the drum, one item
at time. Shake the items before you
put them in the drum.
On the display the weight of the laundry
updates by steps of kg 0.5. The weight is
indicative and changes with the type of
the laundry.
If you put in the drum more
laundry than the maximum
load, the symbol
and
the value start to flash.
You can wash your laundry
but the water and energy
consumption increase. To
have the best consumption
and washing performance
remove some items until the
symbols stop to flash. The
overload indication is
available only for
programmes with a
maximum load lower than
the appliance maximum
load.
3. Close the door.
The value
near the symbol on the
display shows the quantity of the
detergent to use.
This data is indicative and refers to the
detergent quantity for a maximum load
that the manufacturer recommends.
4. Make sure that no laundry stays
between the seal and the door.
www.aeg.com 16