Ariston MCA 15 NA P - Manual (Page 16)

16
NA
Setting machine functions
The user can change a number of the machine’s
operating parameters according to personal preference.
These functions are:
Standby, Rinsing, Language, Contrast, Water hardness,
Temperature, Coffee Size, Quantity of Water, Steam
time, Espresso flavour, Coffee flavour, Long coffee
flavour, Pre-brewing, Counter, Timer, Clock and
Washing cycle.
Programmable functions
STANDBY
When the appliance is used very little, it is possible
to select the STANDBY mode. This function reduces
energy costs. Nevertheless, it is recommended to
switch off the appliance at the mains if it is to be out of
service for long periods. The machine reheats in just a
few minutes when reactivated.
Select the function by pressing the key
STANDBY *
RINSING
and enable with the key. The display shows:
STANDBY
The machine is on but none of its components is active.
To activate the machine press .
RINSING
Immediately after heating, the appliance automatically
eliminates any water left in the internal ducts to ensure
that only fresh water is used to make coffee.
The function has been enabled by the manufacturer.
To disable the function, press the key, select this
function:
RINSING *
LANGUAGE
and enable it with the key. The display shows:
RINSING
ON
Programming
MENU command
To change operating parameters, enter programming
mode with the
key, when the machine is at rest.
In programming, select the required function and press
the
key. This scrolls you through the functions
available on the machine.
To exit the programming, press the key.
Changing individual functions
Select the required function by pressing the key.
Enable the required function with the key. Scroll
through the variables using the key. To save the
required variable, press key.
Note: the key interrupts programming at any time
without saving changes. This operation is only possible
before pressing the
key.