Binatone SPEAKEASY COMBO 2005 TRIPLE - Manual (Page 32)

30
.
You may need to change the recall (flash) time if your phone is connected
to a PBX. The recall time options are SHORT (the default value of 100ms),
1. Press <MENU/OK> and <UP/DOWN> to select BS SETTINGS.
2. Press <MENU/OK> and <UP/DOWN> to select FLASH TIME.
3. Press <MENU/OK> and <UP/DOWN> to select your desired flash time
(SHORT, MEDIUM, LONG, with the current setting indicated by an
4. Press <MENU/OK> to confirm.
A 4-digit system PIN code is used for changing the system settings of the
base station. It is used to protect your phone against unauthorised use.
The default system PIN code is 0000.
1. Press <MENU/OK> and <UP/DOWN> to select BS SETTINGS.
2. Press <MENU/OK> and <UP/DOWN> to select CHANGE PIN.
3.
Press <MENU/OK> to show PIN?
4. Enter the old system PIN.
5.
6.
Press <MENU/OK> to show CONFIRM?, and enter the new system
Note: If the new PIN entered in Step 6 is not the same as the new system
PIN entered in Step 5, you must enter the new system PIN at
Step 5 again.
7. Press <MENU/OK> to confirm.
MEDIUM (300ms) or LONG (600ms).
asterisk to the right).
Press <MENU/OK> to show NEW PIN?, and enter the new system PIN.
PIN again.
4. Press <MENU/OK> to show CONFIRM?
5. Press <MENU/OK> to confirm, and the phone will be reset to its default
settings.
2. Press <MENU/OK> to show PIN?
3. Enter the 4-digit system PIN (default value 0000).
You can reset your phone to the default settings. After reset, all your
personal settings, call list entries and redial list entries will be deleted,
but your phonebook remains unchanged.
1. Press <MENU/OK> and <UP/DOWN> to select DEFAULT.
8.4.3 Change the Recall (Flash) Time
8.4.4 Change the System PIN Code
8.4.5 Reset your Cordless Handset