Olympus LS-10 - Manual (Page 19)

19
Abou
t Recor
ding
2
MIC SENSE HIGH
MIC SENSE
LOW
L R
Key map
When recording with the
built-in microphone:
Turn the microphone in the direction
of the source to be recorded.
About Recording
Before Recording
Getting Ready
Affi x the windscreen:
Start recording after attach the
windscreen (included within) to
the microphone. The noise may
occur even if a windscreen is at-
tached when forcing wind blows
against a microphone.
Turn the Microphone Toward the Original Sound Source
Select the media for recording:
The built-in flash memory as well as an SD
Card can be used ( ☞ P.14, P.34, P.39).
Select the recording format:
Recording can be performed through the
linear PCM format, as well as the WAV, MP3
and WMA formats ( ☞ P.34, P.36).
Turn the built-in stereo microphone in the direction that you would like to record. Placing the built-in stereo
microphone over the display is the proper position for performing stereo recording. If it is below the display
when recording then proper stereo recording cannot be performed because the position of the original
sound will be recorded in reverse phase.
On mounting:
Accurate adjustments of the microphone’s angle and
the like can be made when the device is affixed to a
commercially available tripod used for cameras.
About the built-in stereo microphone:
The direction of capturing sound by the microphone can
be changed with the MIC SENSE HIGH/LOW switch
(
☞ P.24).