Olympus LS-10 - Manual (Page 33)

33
About Pla
ybac
k
3
Erasing
3
Press the 2 button to select [All
Erase].
4
Press the `/OK button.
• The display changes to [All Erase!] and
erasing will start . [Erase Done] is displayed
when the files are erased.
Notes
• An erased file cannot be restored. When an
SD Card is inserted in the recorder, be sure
to confirm the recording media as either the
[Built-in Memory] or the [SD Card] so that
there is no mistake ( ☞ P.34, P.39).
• When attempting to perform operations such as
rewriting the contents of an SD Card in cases
where the card has been write protected, [SD
Card Locked] will appear. The playback opera-
tion can be performed, but the write protection
must first be turned off when overwriting the
contents on the card ( ☞ P.15).
• The locked files and files set as read-only
cannot be erased ( ☞ P.34, P.39).
• If an action is not selected within eight seconds
on the [Cancel], [Erase] or [All Erase] screens,
the recorder will return to stop status.
• Never perform operations such as the following
while processing, as they may damage the
data. In addition, replace the batteries with two
new ones in order to ensure that the batteries
will not run out while processing.
1 Turning off the power while processing.
2 Removing the batteries while processing.
3 Remove the [SD Card] during processing
when it is being used as the recording
media.
Performing any of these operations may dam-
age the data.
• You cannot delete folders through the re-
corder.