Getting started 04, About epg download, Checking the downloaded data the following day – Pioneer RCS-656HX User Manual
Page 61
Getting started
04
61
En
About EPG download
• EPG data can only be received when the recorder is
in standby. (When not using the recorder, therefore,
please switch it into standby.) If you’re using an
external receiver, leave this on when EPG data is
downloading.
• If you cannot receive any of the host channels (see
the above table) then you won’t be able to use the
GUIDE Plus+ system. In this case do not set the
postal code (or set Country to
Other) in the GUIDE
Plus+ setup screen. (When GUIDE Plus+ service
starts in your area, set the postal code again.)
If digital broadcasts start in your area, please set the
EPG Type Select setting in the Initial Setup menu to
Digital EPG.
• Even if you can’t use the EPG functions where you
live, you can still set ShowView timer recordings and
manual recordings — see Setting a manual recording
on page 70.
• The front panel display shows
EPG when receiving
data. If you power on the recorder during an EPG
download, the download is canceled.
• EPG data may be received several times a day. All
updates are automatic.
• When downloading EPG data, the recorder may
sound as though it is on. This is normal.
Checking the downloaded data the
following day
1
Display the GUIDE Plus+ screen.
You should see a grid filled with channel logos and TV
listings information. Use the
/ buttons to review the
list. If you notice that there are channels missing, or that
there are channels in the list that you don’t get, go to the
Editor screen:
• Press
repeatedly until the Menu bar is highlighted.
• Press
until
Editor is highlighted. The main area of
the screen now shows a list of channels. Those that
are turned
ON are displayed in the grid; those that
are
OFF are hidden. Use the
/ / / buttons to
move down the list and turn channels
ON or OFF as
necessary.
• For any channel that you turn
ON, the GUIDE Plus+
system will need to know how it is received (the
source) and on which program number. The source
may be the built-in tuner of this recorder, or an
external receiver. The program number is the number
on which the channel can be found on its receiving
device/source. The entry in the Editor screen must
match this number for correct recording of that
channel.
• The above is especially important for the ‘host
channel’. Please make sure that the host channel is
always switched
ON.
2
Change the program numbers as you like.
Changing the program numbers allows you to decide the
order in which the channels change when stepping
through them sequentially. You can do this to group
certain channels together, for example.
3
When you’re done, press the BLUE Action button
(Home) to get back to the GUIDE Plus+ home screen.
• You can find detailed information on using the GUIDE
Plus+ system in the following chapter.
GUIDE
SET UP
MCACC
ADVANCED
TEST TONE
SR
+
/TUNE
+
ENTER
/TUNE
–
/ST
–
/ST
+
1
2
3
4
5
6
7
8
0
9
D. TV
001
D. TV
002
D. TV
003
D. TV
004
D. TV
005
Ext. Rec. 1
007
D. TV
006
D. TV
014
D. TV
017
BBC1
Name
On/Off Source
Prog. No.
On
BBC2
On
ITV
On
CH4
On
CH5
On
BBC3
On
ITV2
On
E4
Off
UKGOL
On