Pioneer XW-NAV1-K - Manual (Page 37)

Additional information 13
37
En
English
Français
Español
When connected to an HDMI-compatible device
Folder or file names are not
displayed in alphabetical
order.
This is not a problem with this
unit.
The order of the folder and file names displayed on the Disc
Navigator depends on the order in which the folders or files
were recorded on the USB device.
Much time is required to
recognized the USB
device.
What is the USB devices capacity? Some time may be required to load the data when large
capacity USB devices are connected (this could take several
minutes).
Power is not supplied to
the USB device.
Is Err displayed on the front panel
display? No power is supplied if
the power consumption is too
high.
Turn the power off then back on.
Turn the power off, then disconnect and reconnect the USB
device.
Press FUNCTION to switch to the other mode, then switch
again to the USB mode. (When the input is switched back to
USB, ‘ ’ is displayed on the front panel display.)
If the USB device is equipped with an AC adapter, use the USB
device with the AC adapter connected.
Audio CD tracks cannot be
recorded on a USB device.
Is there enough free space on the
USB device?
Recording is not possible if there is not enough free space left
on the USB device. In this case, Available USB space is low
is displayed.
Are there 300 or more folders on
the USB device?
Recording is not possible if the USB device contains 300 or
more folders.
Are there already 99 PIONEER
folders on the USB device?
Recording is not possible if there are already 99 PIONEER
folders on the USB device.
Problem Check Remedy
Picture is not displayed. Is the resolution properly set? Set HDMI Resolution properly for the connected device
(page 26).
Restore HDMI Resolution to the default setting (720x480p/
720x576p
) (page 27).
Is the HDMI cable properly
connected?
Connect the cable securely (all the way in).
With some cables, 1080p video signals will not be output.
Sound is not produced or
is distorted.
Is HDMI Out properly set? Set HDMI Out to LPCM (2CH) or Auto (page 26).
Multichannel audio signals
are not output.
Is HDMI Out properly set? Set HDMI Out to Auto (page 26).
Colors are not properly
displayed on TV screen.
Is HDMI Color properly set? Change the HDMI Color setting (page 26).
Problem Check Remedy
XW-NAV1_VXZT5.book 37 ページ ２０１０年５月１４日 金曜日 午前１０時３８分