Pioneer FH-P80BT - Manual (Page 52)

Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
! Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press MULTI-CONTROL and hold until
the initial setting menu appears in the dis-
play.
3 Turn MULTI-CONTROL to select one of
the initial settings.
Turn
MULTI-CONTROL to switch between the
functions in the following order.
CALENDAR (calendar)
—CLOCK (clock)—
OFF CLOCK (off clock)
—FM STEP (FM tuning
step)
—AUTO PI (auto PI seek)—AUX1 (auxili-
ary input 1)
—AUX2 (auxiliary input 2)—
DIMMER (dimmer)
—S/W CONTROL (rear
output and subwoofer controller)
—MUTE
(sound muting/attenuation)
—
DEMONSTRATION (feature demo)
—
EVER-SCROLL (ever scroll)
—TITLE (language
selection)
—BT AUDIO (Bluetooth audio)—
PIN CODE INPUT (pin code input)
—
EDIT DEVICE NAME (device name edit)
—
BT VERSION INFO. (Bluetooth version infor-
mation)
—BT RESET (Bluetooth reset)—
SOFTWARE UPDATE (software update)
Use the following instructions to operate each
particular setting.
# You can also select the function by pressing
FUNCTION on the remote control.
# To cancel initial settings, press BAND.
Setting the date
The calender display adjusted in this mode ap-
pears when the telephone source is selected
or sources and the feature demo are off.
1 Display the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Use MULTI-CONTROL to select
CALENDAR.
3 Push MULTI-CONTROL left or right to
select the segment of the calendar display
you wish to set.
Pushing
MULTI-CONTROL left or right will se-
lect one segment of the calendar display:
Day
—Month—Year
As you select segments of the calendar dis-
play the segment selected will blink.
4 Push MULTI-CONTROL up or down to
set the date.
Pushing
MULTI-CONTROL up will increase
the selected day, month or year. Pushing
MULTI-CONTROL down will decrease the se-
lected day, month or year.
Setting the clock
Use these instructions to set the clock.
1 Display the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Use MULTI-CONTROL to select CLOCK.
3 Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing
MULTI-CONTROL left or right will se-
lect one segment of the clock display:
Hour
—Minute
As you select segments of the clock display,
the selected segment blinks.
4 Push MULTI-CONTROL up or down to
put a clock right.
Initial Settings
En
52
Section
04