Visit our website, In case of trouble, Resetting the microprocessor – Pioneer FH-P80BT User Manual

Page 8: About the demo mode, Use and care of the remote control, Installing the battery 8, Before you start

Advertising
background image

Visit our website

Visit us at the following site:
http://www.pioneer.co.uk

! Register your product. We will keep the de-

tails of your purchase on file to help you
refer to this information in the event of an
insurance claim such as loss or theft.

! We offer the latest information about

Pioneer Corporation on our website.

In case of trouble

Should this product fail to operate properly,
contact your dealer or nearest authorized
Pioneer Service Station.

Resetting the microprocessor

The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time

after installation

! If the unit fails to operate properly

! When strange or incorrect messages ap-

pear on the display

RESET button

% Press RESET with a pen tip or other
pointed instrument.

About the demo mode

This unit features the feature demo mode.

Important

The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.

Feature demo mode
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Press

DISP

during feature demo operation to cancel the
feature demo mode. Press

DISP again to start.

Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.

Use and care of the remote
control

Installing the battery

Slide the tray on the back of the remote con-
trol out and insert the battery with the plus (+)
and minus (

–) poles aligned properly.

! When using for the first time, pull out the

film protruding from the tray.

WARNING

Keep the battery out of the reach of children.
Should the battery be swallowed, consult a doc-
tor immediately.

CAUTION

! Use one CR2025 (3 V) lithium battery.
! Remove the battery if the remote control is not

used for a month or longer.

! There is a danger of explosion if the battery is

incorrectly replaced. Replace only with the
same or equivalent type.

Before You Start

En

8

Section

01

Advertising