Operator safety, Date of purchase: engine model, Safety and control symbols – Briggs & Stratton 540000 User Manual

Page 4

Advertising
background image

4

BRIGGSandSTRATTON.COM

General Information

For replacement parts or technical assistance, record below the engine model, type, and

code numbers along with the date of purchase. These numbers are located on your

engine (see the Features and Controls page).

Date of purchase:

Engine model:

MM/DD/YYYY

Model:

Code:

Type:

Engine Power Rating Information

The gross power rating for individual gas engine models is labeled in accordance with

SAE (Society of Automotive Engineers) code J1940 (Small Engine Power & Torque

Rating Procedure), and rating performance has been obtained and corrected in

accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060

RPM; horsepower values are derived at 3600 RPM. Actual gross engine power will be

lower and is affected by, among other things, ambient operating conditions and

engine-to-engine variability. Given both the wide array of products on which engines are

placed and the variety of environmental issues applicable to operating the equipment,

the gas engine will not develop the rated gross power when used in a given piece of

power equipment (actual “on-site” or net power). This difference is due to a variety of

factors including, but not limited to, accessories (air cleaner, exhaust, charging, cooling,

carburetor, fuel pump, etc.), application limitations, ambient operating conditions

(temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing

and capacity limitations, Briggs & Stratton may substitute an engine of higher rated

power for this Series engine.

Operator Safety

Explosion

Toxic Fumes

Moving Parts

Shock

Hot Surface

Kickback

Fire

Fuel Shutoff

Read Manual

Choke

Oil

Fuel

On Off

Stop

Wear Eye

Protection

Slow

Fast

SAFETY AND CONTROL SYMBOLS

Hazardous

Chemical

Frostbite

The safety alert symbol

is used to identify safety information about hazards that can

result in personal injury. A signal word (DANGER, WARNING, or CAUTION) is used with the

alert symbol to indicate the likelihood and the potential severity of injury. In addition, a hazard

symbol may be used to represent the type of hazard.

DANGER

indicates a hazard which, if not avoided, will result in death or

serious injury.

WARNING

indicates a hazard which, if not avoided, could result in death or

serious injury.

CAUTION

indicates a hazard which, if not avoided, might result in minor or

moderate injury.

CAUTION,

when used without the alert symbol, indicates a situation that

could result in damage to the product.

The engine exhaust from this product contains chemicals known to

the State of California to cause cancer, birth defects, or other

reproductive harm.

WARNING

Briggs & Stratton does not approve or authorize the use of these

engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes,

fun/recreational go-karts, aircraft products, or vehicles intended for

use in competitive events. Use of these engines in such applications

could result in property damage, serious injury (including paralysis),

or even death.

WARNING

CAUTION: This engine was shipped from Briggs & Stratton without oil. Before you start

the engine, make sure you add oil according to the instructions in this manual. If you

start the engine without oil, it will be damaged beyond repair and will not be covered

under warranty.

WARNING

Gasoline and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.

When Adding Fuel

Turn engine off and let engine cool at least 2 minutes before removing the fuel cap.

Fill fuel tank outdoors or in well-ventilated area.

Do not overfill fuel tank. Fill tank to approximately 1.5 inches (38 mm) below top of

neck to allow for fuel expansion.

Keep gasoline away from sparks, open flames, pilot lights, heat, and other ignition

sources.

Check fuel lines, tank, cap, and fittings frequently for cracks or leaks. Replace if

necessary

If fuel spills, wait until it evaporates before starting engine.

When Starting Engine

Ensure that spark plug, muffler, fuel cap and air cleaner (if equipped) are in place

and secured.

Do not crank engine with spark plug removed.

If engine floods, set choke (if equipped) to OPEN/RUN position, move throttle (if

equipped) to FAST position and crank until engine starts.

When Operating Equipment

Do not tip engine or equipment at angle which causes gasoline to spill.

Do not choke the carburetor to stop engine.

Never start or run the engine with the air cleaner assembly (if equipped) or the air

filter (if equipped) removed.

When Changing Oil

If you drain the oil from the top oil fill tube, the fuel tank must be empty or fuel can

leak out and result in a fire or explosion.

When Transporting Equipment

Transport with fuel tank EMPTY or with fuel shut-off valve OFF.

When Storing Gasoline Or Equipment With Fuel In Tank

Store away from furnaces, stoves, water heaters or other appliances that have pilot

light or other ignition source because they can ignite gasoline vapors.

Starting engine creates sparking.
Sparking can ignite nearby flammable gases.
Explosion and fire could result.

WARNING

If there is natural or LP gas leakage in area, do not start engine.

Do not use pressurized starting fluids because vapors are flammable.

Engines give off carbon monoxide, an odorless, colorless, poison gas.
Breathing carbon monoxide can cause nausea, fainting or death.

WARNING

Start and run engine outdoors.

Do not start or run engine in enclosed area, even if doors or windows are open.

Advertising