Pioneer DEH-P7400MP - Manual (Page 38)

Audio Adjustments
Adjusting bass
You can adjust the cut-off frequency and the
bass level.
• In
FRT1 mode, bass adjustment affects only
the rear output: front output cannot be
adjusted.
1 Press AUDIO to select Bass .
Press AUDIO until Bass appears in the display.
2 Select the desired frequency with
2/3.
Press
2 or 3 until the desired frequency
appears in the display.
40 — 63 — 100 — 160 (Hz)
3 Press
5 or ∞ to adjust the bass level.
Each press of
5 or ∞ increases or decreases
the bass level. +6 – –6 is displayed as the level is
increased or decreased.
Adjusting treble
You can adjust the cut-off frequency and the
Treble level.
• In
FRT1 and FRT2 modes, treble adjustment
affects only the front output: rear output cannot
be adjusted.
1 Press AUDIO to select Treble .
Press AUDIO until Treble appears in the display.
2 Select the desired frequency with
2/3.
Press
2 or 3 until the desired frequency
appears in the display.
2.5k — 4k — 6.3k — 10k (Hz)
3 Press
5 or ∞ to adjust the treble level.
Each press of
5 or ∞ increases or decreases
the treble level. +6 – –6 is displayed as the level is
increased or decreased.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO to select Loud .
Press AUDIO until Loud appears in the display.
2 Press
5 to turn loudness on.
Loudness level (e.g., Loud Mid ) appears in the
display.
3 Press
2 or 3 to select the level.
Press
2 or 3 until the desired level appears in
the display.
Low (low)— Mid (mid)— High (high)
4 Press
∞ to turn loudness off.
Loud OFF appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off.
1 Press AUDIO to select Sub-W1 .
When the subwoofer controller setting is S.W
Control:EXT , you cannot select Sub-W1 . Press
AUDIO until Sub-W1 appears in the display.
2 Press
5 to turn subwoofer output on.
Sub-W1 Normal appears in the display.
Subwoofer output is now on.
• You can turn off subwoofer output by pressing
∞.
3 Press
2 or 3 to select the phase of sub-
woofer output.
Press
2 to select reverse phase and
Rev.
appears in the display. Press
3 to select normal
phase and Normal appears in the display.
En 38
08
Section