Pioneer DDJ-SP1 - Manual (Page 20)

En 20
Changing this unit’s settings
The following settings can be changed:
Setting preferences
Name of selected item Initial settings
Sampler velocity mode velocity curve
selection
Curve 1
Sampler velocity mode after-touch
setting
After-touch disabled
Setting of method to enter sampler
velocity mode
Enter sampler velocity mode when
[SAMPLER] button pressed while press-
ing [SHIFT] button.
Setting of DJ software to be used Use Serato DJ
Demo mode setting Turn demo mode on
Setting of slip mode flashing Slip mode flashing enabled
Setting of illumination when tracks are
loaded
Illumination type 1
Advanced MIDI settings Advanced MIDI disabled
Changing the sampler velocity mode’s
velocity curve setting
Use the procedure below to set the sampler velocity mode’s velocity
curve. You can choose one of four types of velocity curves.
! By default, curve 1 is set.
1 Press the [BACK] button for over 1 second to switch
to the utilities mode.
2 Turn the rotary selector so that the FX1 effect
parameter 1 button flashes.
1
3
4
2
3 4
2
1
ON FX
SELECT
ON FX
SELECT
ON FX
SELECT
TAP FX
MODE
3 Use the performance pads on the left to select the
velocity curve.
The currently selected velocity curve is indicated by which pads are
flashing.
Curve 1 Curve 2 Curve 4 Curve 3
Curve 1
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Curve 2
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Curve 3
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Curve 4
MIDI
code
Strength which
performance pad is pressed
Min. Max.
4 Press the rotary selector.
This saves the parameters that have been set in this unit’s memory.
While the parameters are being saved, the eight buttons in the effect sec-
tion flash. Do not disconnect the USB cable from this unit during this time.
5 Press the [BACK] button.
This unit switches from the utilities mode back to normal operation.
Enabling the sampler velocity mode’s
after touch setting
When the sampler velocity mode is turned on for this unit’s performance
pads, the after touch setting can be turned on and off.
After touch setting disabled: The sampler volume changes according
to the strength with which the performance pad is initially pressed, but
does not keep changing while the pad is held after it is initially pressed.
After touch setting enabled: The sampler volume changes according to
the strength with which the performance pad is initially pressed and the
strength with which the pad is held after it is initially pressed.
! By default, the after touch setting is disabled.
1 Press the [BACK] button for over 1 second to switch
to the utilities mode.
2 Turn the rotary selector so that the FX1 effect
parameter 2 button flashes.
1
3
4
2
3 4
2
1
ON FX
SELECT
ON FX
SELECT
ON FX
SELECT
TAP FX
MODE
3 Press pad 1 or pad 2 on the left performance pads.
! Pad 1 flashing: After-touch disabled
! Pad 2 flashing: After-touch enabled