Pioneer DEH-X8500DAB - Manual (Page 6)

1 Turn M.C. to change the year.
2 Press M.C. to select day.
3 Turn M.C. to change the day.
4 Press M.C. to select month.
5 Turn M.C. to change the month.
6 Press M.C. to confirm the selection.
Clock (setting the clock)
1 Turn M.C. to adjust hour.
2 Press M.C. to select minute.
3 Turn M.C. to adjust minute.
4 Press M.C. to confirm the selection.
FM step (FM tuning step)
1 Turn M.C. to select the FM tuning step.
50kHz (50 kHz)
—100kHz (100 kHz)
2 Press M.C. to confirm the selection.
Contrast (display contrast setting)
1 Turn M.C. to adjust the contrast level.
0 to 15 is displayed as the level is increased or de-
creased.
2 Press M.C. to confirm the selection.
Quit appears.
5 To finish your settings, turn M.C. to se-
lect YES.
# If you prefer to change your setting again, turn
M.C. to switch to NO.
6 Press M.C. to select.
Notes
! You can set up the menu options from the sys-
tem menu. For details about the settings, refer
to System menu on page 29.
! You can cancel set up menu by pressing SRC/
OFF.
Basic operations
Important
! Handle the front panel with care when remov-
ing or attaching it.
! Avoid subjecting the front panel to excessive
shock.
! Keep the front panel out of direct sunlight and
high temperatures.
! To avoid damaging the device or vehicle inter-
ior, remove any cables and devices attached
to the front panel before detaching it.
Removing the front panel to protect your unit from
theft
1 Press the detach button to release the front
panel.
2 Push the front panel upward (M) and then pull it
toward ( N) you.
3 Always store the detached front panel in a protec-
tive case or bag.
Re-attaching the front panel
1 Slide the front panel to the left.
Make sure to insert the tabs on the left side of the
head unit into the slots on the front panel.
2 Press the right side of the front panel until it is
firmly seated.
If you cannot attach the front panel to the head
unit successfully, make sure that you are placing
the front panel onto the head unit correctly. For-
cing the front panel into place may result in da-
mage to the front panel or head unit.
Turning the unit on
1 Press SRC/OFF to turn the unit on.
Turning the unit off
1 Press and hold SRC/OFF until the unit turns off.
En
6
Section
02 Using this unit