Pioneer AVIC F900BT - Manual (Page 130)

p Operation returns to normal when the cor-
respond action is ended.
p When “SD” or “USB” selected as the AV
source, the AV sounds, the navigation gui-
dance and beep sounds are mixed and the
volume can be adjusted simultaneously.
Setting the rear output
The navigation system
’s rear output can be
used for a full-range speaker or subwoofer
connection. If you switch
Rear SP to Sub W,
you can connect a rear speaker lead directly to
a subwoofer without using an auxiliary amp.
Initially, the navigation system is set for a rear
full-range speaker connection (
Full).
1 Touch [Rear SP] on the
“AV Settings”
menu.
= For details, refer to Displaying the “AV Set-
tings ” menu on page 128.
2 Touch [Rear SP] to switch the rear out-
put setting.
When no subwoofer is connected to the rear
output, select
Full.
When a subwoofer is connected to the rear
output, select
Sub W.
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting is ef-
fective for rear speaker leads only.)
Switching Auto PI seek
The navigation system can automatically
search for a different station with the same
programming, even during preset recall.
% Touch [Auto PI] on the “AV Settings”
menu.
= For details, refer to Displaying the “AV Set-
tings
” menu on page 128.
Touching [ Auto PI] switches between [On]
and [ Off].
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When
AF or TA is on,
the tuning step automatically changes to
100 kHz. It may be preferable to set the tuning
step to 50 kHz when
AF is on.
% Touch [FM Step] on the “AV Settings”
menu.
= For details, refer to Displaying the “AV Set-
tings
” menu on page 128.
Each time you touch [ FM Step] will switch the
FM tuning step between 50 kHz and 100 kHz
while
AF or TA is on.
p The tuning step remains at 50 kHz during
manual tuning.
Customising preferences
Engb
130
Chapter
21