Pioneer EFX-1000 - Manual (Page 17)

17
OPERATIONS
OPERATIONS
Adjusting Input Level
Adjust the input level so that the sound is not distorted due
to an excessive input level.
7 Input signals to the input connectors, and rotate the
INPUT LEVEL dial to adjust the level.
¶ Use the METER MODE button to select “input stereo
display” (INPUT, L, R indicators light).
¶ If the proper adjustment cannot be obtained without
rotating the INPUT LEVEL dial to its extreme [MIN] or
[MAX] positions, try changing the position of the rear-panel
IN&OUT LEVEL switch (–10dB / +4dB).
Adjusting Effect Output Level
Adjusts the sound level of the effect applied to the input
sound signal by the beat effect and the digital jog break.
7 Input signals to the input connectors, and rotate the
EFFECT OUT LEV. dial to adjust the effect output level.
¶ Use the METER MODE button to select “output stereo
display” (OUTPUT, L, R indicators light).
¶ When both the BEAT EFFECTS lever switch and the DIGITAL
JOG BREAK lever switch are set to [OFF], the output level is
not changed by turning the EFFECT OUT LEV. dial.
Selecting Signal Flow
Select the order in which signal processing occurs (beat
effect or digital jog break)
7 Use the SIGNAL FLOW switch to select the signal
processing order:
¶ When set to the [JOG=BEAT] position, signals are
processed for digital jog break effects first, followed by beat
effects .
¶ When set to the [BEAT=JOG] position, signals are
processed for beat effects first, followed by digital jog break
effects.
Selecting Foot Switch Operation
This effector allows connection of an optional foot switch
(pedal switch) for ON/OFF control of beat effects and digital
jog break effects. Use the foot switch to select the way in
which the foot switch operates.
7 Set the FOOT SW switch to the desired operating
position:
¶ When set to the [JOG] position, the foot switch operates to
turn digital jog break effects ON/OFF.
¶ When set to the [BOTH] position, the foot switch operates to
turn both digital jog break effects and beat effects ON/OFF.
INPUT LEVEL FOOT SW MIDI (TRANSMIT/RECEIVE/OFF) EFFECT OUT LEV.
SIGNAL FLOW METER MODE BYPASS
¶ When set to the [BEAT] position the foot switch operates to
turn beat effects ON/OFF.
* Use a commercially available switching-type foot switch
with 6.3 mm monaural phone plug.
Selecting the Level Meter Display
This unit’s level meter can be set to display the desired
mode.
7 Press the METER MODE button to select the desired
mode.
¶ Each time the METER MODE button is pressed, the display
switches alternately as follows:
[INPUT] and [OUTPUT] light:
= Input and output level are displayed in monaural.
[INPUT] and [L], [R] light:
= Input level is displayed in stereo.
[OUTPUT] and [L], [R] light:
= Output level is displayed in stereo.
Digital Link Function
Fader Effect Function
When the accessory digital link cable is used to connect
this unit to a DJ mixer (DJM-1000) with digital link support,
send/return connections are completed by a single digital
connection, thus enabling fader effect functions that allow
the DJ mixer’s fader to be used to perform digital jog break.
Bypass Function
This function allows signals to be output directly, without
passing through the effects processing circuitry.
7 Press the BYPASS button to make a direct link between
input and output.
¶ When the BYPASS button is pressed, the button flashes and
input signals are output directly, without passing through
the effector circuitry.
¶ When the BYPASS button is flashed, the unit’s controls will
have no effect on the input signals.