Pioneer EFX-1000 - Manual (Page 19)

19
Operations (Beat Effects [RHYTHM mode])
BPM MODE 1) RHYTHM MODE 5) TAP
MIX
DEPTH
3) EFFECT
FREQUENCY
LOW, MID, HI
CHARACTER
TIME
7) BEAT EFFECTS
2) DELAY, ECHO, PITCH ECHO, TRANS,
FLANGER, FILTER, PHASER
6) 1/8, 1/4, 1/2, 3/4, 1/1, 2/1, 4/1, 8/1 4) Rhythm REC
(beat select)
(beat effect select)
Beat Effects [RHYTHM mode]
The beat effects [RHYTHM mode] function allows you to
create a variety of effects synchronized with your own
input rhythm.
1. Use the RHYTHM MODE button to set to rhythm mode.
¶ The RHYTHM MODE button lights.
2. Use the beat effect select buttons to select the desired
effect.
¶ Select from DELAY, ECHO, PITCH ECHO, TRANS,
FLANGER, FILTER, or PHASER.
¶ The selected effect button flashes.
¶ See pages 10, 11 regarding each effect.
3. Use the EFFECT FREQUENCY buttons (LOW, MID, HI) to
select the band to which the effect is to be applied.
¶ When a button is pressed, the button’s indicator will light.
¶ Each time a button is pressed, it alternates ON/OFF.
4. Press rhythm REC button to set to REC mode.
¶ The BPM display will indicate “ ”.
¶ If no rhythm has been input, the unit will automatically
enter the REC mode in step 1.
5. Input the desired rhythm using the TAP button.
¶ Input taps will be recognized as a tempo when occurring at
intervals of less than 2 seconds. Up to 8 taps can be input.
¶ The counted taps (RHYTHM TAP) will be shown in the
display.
¶ During rhythm input, the beat select button [1/1] will be
selected.
6. Select one of the beat select buttons to establish the
overall time for the input rhythm.
¶ The overall time for the input rhythm will be multiplied in
response to the selected button.
¶ Select from 1/8, 1/4, 1/2, 3/4, 1/1, 2/1, 4/1, or 8/1.
¶ The selected beat button lights.
7. Pull the BEAT EFFECTS lever switch to ON to appy the
effect.
When pushed away from you to the [ON/LOCK] position:
The switch is locked on, so that the effect continues to be
applied even if you remove your hand from the lever. To stop
the effect, return the lever to the middle position [OFF].
When pulled toward you to the [ON] position:
The effect is applied only while the lever is pulled to the [ON]
position; when the lever is released, it returns automatically to
the middle [OFF] position. Use this function when you wish to
alternate rapidly between ON and OFF.
¶ If the Rhythm REC button is pressed during the rhythm
mode, the input rhythm will be cleared and rhythm input
mode is once again enabled.
DEPTH dial
Set to the center center indent position for standard effect sounds.
For more information regarding the change in parameter 1 in
response to DEPTH dial rotation, see pages 10, 11, 13.
CHARACTER dial
Set to the center center indent position for standard effect sounds.
For more information regarding the change in parameter 2 in
response to CHARACTER dial rotation, see pages 10, 11, 13.
MIX dial
Use to adjust the mixing balance of original and effect sounds. Set
to the center indent position for standard effect sounds.