Pioneer AVIC-F9210BT - Manual (Page 10)

Connecting the power cord (1)
ISO connector
*1
*3
*2
*4
Speaker leads
White: Front left 
White/black: Front left 
Grey: Front right 
Grey/black: Front right 
Green: Rear left  or Subwoofer  (*5)
Green/black: Rear left  or Subwoofer  (*5)
Violet: Rear right  or Subwoofer  (*5)
Violet/black: Rear right  or Subwoofer  (*5)
Depending on the kind of vehicle, the function
of *2 and *4 may be different. In this case, be
sure to connect *1 to *4 and *3 to *2.
Connect leads of the
same colour to each other.
Yellow (*2)
Back-up
(or accessory)
Red (*4)
Accessory
(or back-up)
Yellow (*1)
To terminal always supplied
with power regardless of
ignition switch position.
Red (*3)
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Note Notes
· When a subwoofer (*5) is connected to this
navigation system instead of a rear speaker, change
the rear output setting in the Initial Setting. (Refer to
Operation Manual.) The subwoofer output of this
navigation system is monaural.
· When using a subwoofer of 70 W (2
Ω), be sure to
connect with violet and violet/black leads of this
navigation system. Do not connect anything with
green and green/black leads.
Engb
10
Section
03 Connecting the System