Pioneer TAD-R1 - Manual (Page 9)

9
TAD Reference One Owner’s Manual
Installing The Spikes
WARNING!
Be sure to use two people when installing
the spikes. Be careful to not pinch your
fingers under the loudspeaker and make
sure the loudspeaker does not fall on its
side.
The installation of spikes on the bottom of the unit
allows you to establish a firm connection between the
ground and the loudspeaker when placing the
loudspeaker on uneven surfaces. The bottom of the
cabinet features three areas for these spikes.
The use of three spikes for support eliminates the need
for fine adjustments, allowing you to keep the
loudspeaker firmly in place. See
Choosing Where To
Place The Loudspeakers on page 10 for help deciding
where to place the loudspeaker, and Figure 5 for how
to install the spikes.
There are screw holes on the aluminum plates located
on the bottom of the cabinets.
Removing The Grille Covers
The bass drivers come equipped with grille covers that
should be removed when the loudspeaker are in use
(see Figure 6). To remove them, grasp each grille along
the edges, pull it out, and store it in a safe place in case
of future use when moving or storing this unit.
Figure 5. Installing the spikes
Figure 6. Removing the grille from the TAD Reference
One loudspeaker
TAD-R1_En.book 9 ページ ２００６年１２月４日 月曜日 午後２時４２分