Britax Monarch - Manual (Page 16)

16
Care and Maintenance
Removing Base Cover
Locate the elastic loops at the back
corners of the base. (Fig. A)
Unfasten elastic loops from plastic
notches on each side of the base and
slide the cover off.
Removing Backrest Cover
Swivel backrest up. Locate the four
notches on the rear of the backrest (two
at the top and two at the bottom).
(Fig. B)
Unfasten the hooks (located under the
backrest cover) by pulling the cover
toward the center of the backrest and
lifting the hooks up and out. Slide
backrest cover off.
A 1
2
Tip: Use a blunt wooden rod (pencil, chopstick, etc.) to assist with untucking the
cover hooks from the shell.
Before removing the cover, place booster seat on a level surface. Lift headrest to
highest level, swivel backrest down and expand base to the widest position.
B
Top of headrest
3
D
C
4
Removing Headrest Cover
Unhook elastic straps from clips at
bottom of backrest. (Fig.C)
Locate the red tabs at each
bottom corner of the headrest
near the color-coded belt guides.
(Fig. D) Push the cover back to
release it from the tabs. Once the
cover is off the tabs, slide it off the
headrest.
To replace the cover, reverse the
directions above.
Shoulder
Belt Guide
Base
Arm
Rest
Base
Arm
Rest
Backrest
Base
Cover Removal