Pioneer DEH-8300SD - Manual (Page 9)

<QRD3068-A> <>
 
 
 
 
25. Power amp
(sold separately)
26. Connect with RCA cables
(sold separately)
27. System remote control
25. Power amp
(sold separately)




25. Power amp
(sold separately)
23. To front output
22. To rear output
30. Rear speaker
28. Subwoofer
29. Front speaker
30. Rear speaker
28. Subwoofer
29. Front speaker
24. To subwoofer output
31. Perform these connections when
using the optional amplifier.
2* 1*
3* 4*
9. Note
Depending on the kind of vehicle,
the function of 2* and 4* may be
different. In this case, be sure to
connect 1* to 4* and 3* to 2*.
10. Connect leads of the
same color to each other.
11. Yellow (2*)
Back-up (or
accessory)
13. Red (4*)
Accessory
(or back-up)
12. Yellow (1*)
Connect to the constant
12 V supply terminal.
14. Red (3*)
Connect to terminal controlled by
ignition switch (12 V DC).
21. Speaker leads
White: Front left 
White/black: Front left 
Gray: Front right 
Gray/black: Front right 
Green: Rear left  or subwoofer 
Green/black: Rear left  or subwoofer 
Violet: Rear right  or subwoofer 
Violet/black: Rear right  or subwoofer 
18. Blue/white
Connect to system control
terminal of the power amp (max.
300 mA 12 V DC).
19. Blue/white (6*)
Connect to auto-antenna relay
control terminal (max. 300 mA
12 V DC).
15. Black (chassis ground)
Connect to a clean, paint-free metal location.
The pin position of the ISO
connector will differ depending
on the type of vehicle. Connect
5* and 6* when Pin 5 is an
antenna control type. In another
type of vehicle, never connect
5* and 6*.
20. Blue/white (5*)
16. ISO connector
Note
In some vehicles, the ISO connector may be
divided into two. In this case, be sure to
connect to both connectors.
17. Yellow/black
If you use an equipment with Mute
function, wire this lead to the Audio Mute
lead on that equipment. If not, keep the
Audio Mute lead free of any connections.
8. Notes
• Change the initial setting of this unit (refer to the
operation manual). The subwoofer output of this unit is
monaural.
• When using a subwoofer of 70 W (2 Ω), be sure to
connect with Violet and Violet/black leads of this unit.
Do not connect anything with Green and Green/black
leads.
1. This product
7. Antenna
jack
6. Fuse (10 A)
5. Wired remote input
Hard-wired remote
control adaptor can
be connected (sold
separately).
2. Rear output
4. Subwoofer output
3. Front output