Pioneer SPH-DA02 - Manual (Page 16)

Installation with the holder
and side bracket
1 Install the holder into the dashboard.
After inserting the holder into the dashboard,
select and bend the tabs appropriate to the
thickness of the dashboard material. (Install
this product as firmly as possible using the
top and bottom tabs. To secure this product,
bend the tabs 90 degrees.)
Dashboard
Holder
2 Install this product and fasten the
screws.
Rubber bush Dashboard
Double-ended screw Screw (2.6 mm × 5 mm)
3 Attach the trim ring.
Trim ring
Installation using the screw
holes on the side of this product
1 Remove the side brackets.
Side bracket
Screw for fixing the side bracket
(5 mm × 7 mm)
2 Fastening the unit to the factory radio-
mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three or four loca-
tions on each side.
Use either the truss head screws (5 mm ×
6 mm) or flush surface screws (5 mm ×
7 mm), depending on the shape of the brack-
et
’s screw holes.
Engb
16
Section
03 Installation