Pioneer SPH-DA02 - Manual (Page 21)

After installing this product
1 Reconnect the negative (
–) terminal of
the vehicle
’s battery.
First, double-check that all connections are
correct and that this product is installed cor-
rectly. Reassemble all vehicle components
that you previously removed. Then reconnect
the negative (
–) cable to the negative (–) term-
inal of the battery.
2 Start the engine.
3 Open the cover of the microSD card
slot.
Press the right side of the cover. The left side
of the cover pops up slightly, so pull it out
gently.
4 Press the reset button.
Press the reset button on this product with a
pointed object such as the tip of a pen.
5 Make the following settings.
= For details concerning operations, refer to
Operation Manual.
1 Set the language.
2 Drive an unobstructed road until the GPS
starts receiving the signal normally.
3 Make some necessary adjustments.
! Setting the time
! Setting the units and the date format,
etc.
! Change other settings as you prefer
Note
After installing this product, be sure to check at a
safe place that the vehicle is performing normal-
ly.
Engb
21
English
Section
04 After installation