Pioneer SPH-DA02 - Manual (Page 8)

Connecting the power cord
ISO connector
Orange/white (ILLUMI)
To lighting switch terminal.
Black (GND)
To vehicle (metal) body.
In some vehicles, the ISO connector may be divided
into two. In this case, be sure to connect to both
connectors.
Note
Yellow (*3)
Back-up
(or accessory)
Red (*5)
Accessory
(or back-up)
Yellow (*2)
To terminal supplied with power
regardless of ignition switch position.
Red (*4)
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
Connect leads of the
same colour to each other.
*2
*4
*3
*5
Depending on the types of vehicles, the
function of *3 and *5 may be different. In this
case, be sure to connect *2 to *5 and *4 to *3
as shown in the figure.
Note
Blue/white (P.CONT)
To P.CONT of control line cable.
*1
Cap (*1)
When not using this terminal,
do not remove the cap.
Engb
8
Section
02 Connecting the system