Pioneer SE-NC70S - Manual (Page 5)

5
En
English
Using the Headphones
To protect your ears from damage, always
rotate the volume dial of the headphones or
your music device to its lowest position before
wearing the headphones.
1 Attach one end of the furnished
connection cord to the headphones, and
the other end to your music playback
device.
2 Adjust the length of the headband as
you place the headphones over your head.
Place the (R) housing over your right ear, and
the (L) housing over your left ear.
3 Use the VOLUME control dial to adjust
the sound volume.
The sound volume can be adjusted even when
the power switch is set to OFF.
Note
• When disconnecting the cord, pull on the
plug, not the cord.
• When connecting the headphones to an
airline onboard audio system, use the
supplied plug adapter (the adapter may not
comply with the systems used on some
airlines).
• Do not use with airline onboard sound
systems under the following conditions:
– Whenever the cabin crew announces
that electronic devices are prohibited.
– When the use of privately owned
headphones is prohibited inside the
plane.
• When not using the headphones, set the
power switch to OFF.
Normal headphones use
1 Set the headphones’ power switch to
OFF.
Music can be heard even when the power
switch is set to OFF. Sound will be produced in
conventional 2-channel stereo playback, but
the noise-canceller and SRS surround effects
will not function.
Noise canceller
1 Set the headphones’ power switch to
ON1.
The green power indicator will light, and sound
will be heard in 2-channel stereo playback. The
noise canceller function will operate, reducing
the effect of environmental noise and allowing
you to listen at a sound volume lower than that
used when the power switch is set to OFF.
WRB1122A.FM 5 ページ ２００９年６月５日 金曜日 午後５時３２分