Pioneer SE-NC70S - Manual (Page 6)

6
En
Noise canceller + SRS surround
*1
function
1 Set the headphones’ power switch to
ON2.
The green power indicator will light, and both
the noise canceller and SRS surround
functions will operate.
*1 The SRS surround function utilizes SRS HEADPHONE
technology developed by SRS Labs, Inc., (USA) to
reproduce headphone sound with a greater sense of
three-dimensional realism. When using headphones
equipped with SRS HEADPHONE technology, music is
not focused on the center of the head, but is
reproduced with a greater sense of natural expanse.
Note
• The noise-canceller function is designed to
reduce noise primarily in the low-frequency
range, and is not effective at reducing high-
frequency noise.
• If the headphones’ microphone is covered
with your hand or other object, feedback
may be caused, resulting in a “howling”
sound. In this case, remove your hand or
other obstruction from the microphone.
• The effectiveness of the noise canceller
function may vary depending on the way in
which the headphones are worn.
After use
1 Set the power switch to OFF.
Sound can still be heard from the headphones
when the power switch is set to OFF, but the
noise-canceller function will not operate to
lower environmental noise.
Storing the headphones
When not in use, store the headphones as
shown below.
1 Reverse the direction of the ear pads.
2 Fold the headband as shown.
3 Fold the headband as shown to align
with the ear pads.
Microphone
WRB1122A.FM 6 ページ ２００９年６月５日 金曜日 午後５時３２分