Pioneer SE-NC70S - Manual (Page 7)

7
En
English
Troubleshooting
If you suspect a malfunction, perform the following checks, since a simple operating error may be
the cause of the problem. The problem may also be caused by factors other than the headphones
themselves, so be sure to check the sound components with which the headphones are used.
If the problem persists after making the following checks, consult your dealer or nearest Pioneer
Service Station.
Precautions
• Do not subject headphones to dropping,
striking, or other severe impacts, since
damage may result.
• To ensure high quality sound reproduction,
keep the plug clean by wiping occasionally
with a soft clean cloth. A dirty plug may
cause degradation of sound quality or
interruption of sound production.
Environmental conditions
• Avoid leaving the headphones in the
following places:
– Automobiles with closed windows, other
locations exposed to direct sunlight, or
nearby heating appliances or places
exposed to high heat.
– Places exposed to high concentrations
of dust.
– Places exposed to high humidity.
Problem Remedy
No sound. • Check connection between headphones and AV system component.
• Confirm that power is turned on to the AV component.
• Adjust the output sound volume on the AV component.
• Adjust the sound volume on the headphones.
Sound is distorted. • Lower the sound volume on the connected AV component.
• Replace the headphone batteries.
Power won’t turn on. • Replace the headphone batteries.
• Check that batteries are installed correctly (are
 and  polarities
correct?).
Feedback sound (howling). • If you are covering the microphone part of the headphone with your
hand, remove your hand.
Noise canceller produces
no effect. • Set the power switch to position ON1 or ON2 (power indicator lights
green).
WRB1122A.FM 7 ページ ２００９年６月５日 金曜日 午後５時３２分