Applying an acls to interfaces, Reapplying modified acls, Named acls – Brocade Communications Systems ServerIron ADX 12.4.00a User Manual
Page 83
ServerIron ADX Security Guide
69
53-1002440-03
Applying an ACLs to interfaces
2
Named ACLs
To display the contents of named ACLs, enter a command such as the following.
ServerIronADX# show ip access-list melon
Standard IP access list melon
deny host 1.2.4.5
deny host 5.6.7.8
permit any
Syntax: show ip access-list <acl-num> | <acl-name>
Applying an ACLs to interfaces
Configuration examples in the section
“Configuring numbered and named ACLs”
on page 54 show
that you apply ACLs to interfaces using the ip access-group command. This section present
additional information about applying ACLs to interfaces.
Reapplying modified ACLs
If you make an ACL configuration change, you must reapply the ACLs to their interfaces to place the
change into effect.
An ACL configuration change includes any of the following:
•
Adding, changing, or removing an ACL or an entry in an ACL
•
Changing a PBR policy
To reapply ACLs following an ACL configuration change, enter the following command at the global
CONFIG level of the CLI.
ServerIronADX(config)# ip rebind-acl all
Syntax: [no] ip rebind-acl <num> | <name> | all