Pioneer DVH-P500UB - Manual (Page 54)

1 Use MULTI-CONTROL to select ILLUMI.
Refer to Adjusting initial settings on page 51.
2 Press MULTI-CONTROL to select the de-
sired setting.
BLUE (blue)
—RED (red)
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
FULL) or subwoofer (SUB W)
connection. If you switch the rear output set-
ting to
SUB W, you can connect a rear speaker
lead directly to a subwoofer without using an
auxiliary amp.
! When the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you
cannot operate this function.
1 Use MULTI-CONTROL to select REAR SP.
Refer to Adjusting initial settings on page 51.
2 Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL will switch be-
tween FULL (full-range speaker) and SUB W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select
FULL (full-range speaker).
# When a subwoofer is connected to the rear
output, select
SUB W (subwoofer).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
44).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the ever scroll
When Ever Scroll is set to ON, recorded text in-
formation scrolls continuously in the display.
Set to OFF if you prefer the information to
scroll just once.
1 Use MULTI-CONTROL to select
EVERSCROLL.
Refer to Adjusting initial settings on page 51.
2 Press MULTI-CONTROL to turn the ever
scroll on.
# To turn the Ever Scroll off, press
MULTI-CONTROL again.
Multi language display setting
Text information such as title name, artist
name or comment can be recorded on a com-
pressed audio disc.
This unit can display them even if they are em-
bedded in a European language or Russian.
! If the embedded language and the selected
language setting are not the same, text in-
formation may not be displayed properly.
! Some characters may not be displayed
properly.
1 Use MULTI-CONTROL to select TITLE.
Refer to Adjusting initial settings on page 51.
2 Press MULTI-CONTROL to select the lan-
guage.
EURO (European language)
—RUSSIA (Rus-
sian language)
Operating this unit
En
54
Section
02