Setting the tv signal 55, Correcting distorted sound 55, Resetting the audio functions 55 – Pioneer DVH-P500UB User Manual

Page 55: Operating this unit, Setting the tv signal, Correcting distorted sound, Resetting the audio functions

Advertising

Setting the TV signal

When this unit is connected to a TV tuner, you
need to adjust the TV signal suitable to your
country TV signal setting.
! About your country TV signal, consult with

your nearest Pioneer dealer.

Use MULTI-CONTROL to select

TV SIGNAL.
Refer to Adjusting initial settings on page 51.

Press MULTI-CONTROL to select an ap-

propriate TV signal.
PAL

—SECAM

Correcting distorted sound

Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to

LOW. Normally, leave the set-

ting at

HIGH to ensure quality sound.

Use MULTI-CONTROL to select D.ATT.

Refer to Adjusting initial settings on page 51.

Press MULTI-CONTROL to switch the di-

gital attenuator setting.

! HIGH – High quality sound
! LOW – Minimize distortion sound

Resetting the audio functions

Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can reset audio functions other than the
following settings.

! Volume setting (refer to Adjusting the vo-

lume on page 18)

! Listening position setting (refer to Using

the position selector on page 68)

! Fader/balance setting (refer to Using bal-

ance adjustment on page 68)

! SLA (source level adjustment) setting (refer

to Adjusting source levels on page 70)

! Dynamic range control (refer to Using the

dynamic range control on page 70)

! Direct control setting (refer to Using the di-

rect control on page 70)