Pioneer X-EM12 - Manual (Page 15)

Bluetooth® Audio playback (X-EM22 only)
15
En
English
Français
Español
06
3 Confirm on the Bluetooth capable device
that pairing has been completed.
• If pairing with the Bluetooth capable device has been
completed correctly, a beep will sound, and the
Bluetooth indicator will switch from blinking to staying
lit.
• If the Bluetooth indicator will not switch from blinking to
staying lit, the pairing was not completed correctly so
please try pairing with the unit again.
• If paring has been completed correctly, you need not
repeat this procedure again.
Even devices that have already been paired with this unit will
not connect during pairing mode in the following cases.
In such cases, delete pairing history from the Bluetooth
wireless technology device and perform pairing again.
In order to pair with the unit, press and hold the  on the
unit for 3 seconds.
• Up to 8 pairing history can be recorded with this unit. If
connecting to a Bluetooth wireless technology device
over 8 units, the oldest pairing history will be deleted.
• If the settings are reset to the factory setting, all pairing
history will be deleted. In order to reset to factory setting,
press and hold the  on the unit for more than 8
seconds.
Listen to music on the unit from a
Bluetooth capable device
1 Press BLUETOOTH on the remote control or
INPUT repeatedly on the main unit to switch the
source to [BT].
The unit will start using the BT function, and connect with a
Bluetooth capable device.
2 A Bluetooth connection will be created
between the Bluetooth capable device and the
unit.
Procedures for connecting to the unit should be performed
from the Bluetooth capable device.
• Please refer to the user’s manual for your Bluetooth
capable device for details of the connection procedures.
3 Playback music from the Bluetooth capable
device.
Note
• When Bluetooth capable devise is not connected and no
operations have been performed for more than 15
minutes, the unit will automatically power off.
Radio wave caution
This unit uses a 2.4 GHz radio wave frequency, which is a
band used by other wireless systems (see list below). To
prevent noise or interrupted communication, do not use this
unit nearby such devices, or make sure these devices are
switched off during use.
• Cordless phones
• Cordless facsimiles
• Microwave ovens
• Wireless LAN devices (IEEE802.11b/g)
• Wireless AV equipment
• Wireless controllers for game systems
• Microwave-based health aids
• Some baby monitors
Other, less common, equipment that may operate on the
same frequency:
• Anti-theft systems
• Amateur radio stations (HAM)
• Warehouse logistic management systems
• Discrimination systems for train or emergency vehicles
Note
• In the event noise appears in your television image, there
is the possibility that a Bluetooth wireless technology
enabled device or this unit (including products
supported by this unit) are causing signal interference
with the antenna input connector of your television,
video, satellite tuner, etc. In this event, increase the
distance between the antenna input connector and the
Bluetooth wireless technology enabled device or this
unit (including products supported by this unit).
• If there is something obstructing the path between this
unit (including devices supported by this unit) and the
device equipped with Bluetooth wireless technology
(such as a metal door, concrete wall, or insulation
containing tinfoil), you may need to change the location
of your system to prevent signal noise and interruptions.
Scope of operation
Use of this unit is limited to home use. (Transmission
distances may be reduced depending on communication
environment).
In the following locations, poor condition or inability to receive
radio waves may cause the audio to be interrupted or stopped:
• In reinforced concrete buildings or steel framed or iron-
framed buildings.
• Near large metallic furniture.
• In a crowd of people or near a building or obstacle.
• In a location exposed to the magnetic field, static
electricity or radio wave interference from radio
communication equipment using the same frequency
band (2.4 GHz) as this unit, such as a 2.4 GHz wireless
LAN device (IEEE802.11b/g) or microwave oven.
X-EM22_SYXE8_En.book 15 ページ ２０１４年６月６日 金曜日 午後３時４９分