Pioneer AVIC-X3 - Manual (Page 13)

Violet/White (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system can detect whether the vehicle is moving
forwards or backwards. Connect the violet/white lead to the lead whose voltage changes when
the reverse gear is engaged. Unless connected, the sensor may not detect your vehicle travelling
forward/backward properly, and thus the position of your vehicle detected by the sensor may be
misaligned from the actual position.
• When you use the ND-PG1 speed pulse
generator (sold separately), please make sure
to connect this lead.
• When you use a rear view camera, please
make sure to connect this lead. Otherwise you
cannot switch to rear view camera picture.
Be sure to use only the supplied extension lead. Use of another
lead could cause fire, smoke and/or damage this navigation
system.
Connection method
Check the position of your
vehicle’s reversing lamp (the one
that lights up when the gearstick is
in reverse [R]) and find the
reversing lamp lead in the boot.
Extension lead
(for reverse signal)
The display unit
5 m
Reversing
lamp lead
Clamp the reversing
lamp lead.
Clamp firmly with
needle-nosed
pliers.
Cords for this navigation system and those for
other products may be different colors even if they
have the same function. When connecting this
navigation system to another product, refer to the
supplied manuals of both products and connect
cords that have the same function.
Note
Notes
CAUTION
Yellow/Black (GUIDE ON)
When combining this navigation system with the
other Pioneer audio unit for the vehicle, if the vehicle
stereo has yellow/black leads, connect them to those
leads. In this way, the vehicle stereo is automatically
muted to reduce the vehicle stereo volume when;
– the guidance audio is output.
– the mobile phone is used via Bluetooth adapter.
Fuse resistor
30 cm
Power cord
Connecting the System
Engb
13
English
Section
03