Bosch GWH-635-ESO - Manual (Page 12)

12
Remote control installation
6 720 606 990
B On heater control panel, press and
hold Program key while
pressing the ON/OFF button to ON.
Release program key when LCD
displays “188”.
LCD shows “P2”. If not, repeat
previous step.
1. Press the button on the
heater to select "P3".
B Press and hold Program key
again for 1 sec.
LCD shows one number and one
rotating digit. If not, repeat previous
step.
The number represents the remote
control which is to be registered, the
first remote control will be registered
with number “0”, the second with
number “1” and so on.
The rotating digit shows that the
electronics is expecting a registration.
If the LCD fails to show a number and
rotating digit after repeated attempts,
double check the wire connections
made in section 5.1.
B Hold remote control in front of the
control panel on the heater and
simultaneously press remote control
buttons
and until the
temperature indication is shown on
the remote control LCD.
B Press ON / OFF button on the
appliance to OFF position and then
back ON.
B Press buttons or to reach
desired temperature.
New remote control is programmed.
6720606990-0701_(Remote control)16Nov.fm Page 12 Friday, November 16, 2007 3:04 PM