Bosch GWH-635-ESO - Manual (Page 9)

9
Remote control installation
6 720 606 990
B Switch power switch on the
appliance to the "OFF" (0) position
and then back "ON" (I).
B Press buttons or in order
to reach desired temperature.
New remote control is programmed.
4.2.2 SU board
B Connect power to heater.
B Move the main switch on the
appliance to the "OFF" (0) position.
B Press and hold key while at the
same time turning the main switch to
“ON” position (I).
LCD shows one number and one
rotating digit. If not repeat previous
step.
The number represents the remote
control which is to be registered, the
first remote control will be registered
with number “0”, the second with
number “1” and so on.
The rotating digit shows that the
electronics is expecting a registration.
If the LCD fails to show a number and
rotating digit after repeated attempts,
double check the wire connections
made in section 4.1.
B Hold remote control in front of the
control panel on the heater and
simultaneously press remote control
buttons
and until the
temperature indication is shown on
the remote control LCD.
B Switch ON/OFF switch to “OFF”
position (0) and then back on (I).
B Press buttons or in order
to reach requested temperature.
New remote control is programmed.
6720606990-0701_(Remote control)16Nov.fm Page 9 Friday, November 16, 2007 3:04 PM