Bosch GWH-635-ESO - Manual (Page 15)

15
Remote control
6 720 606 990
6.4 "Priority" function
The remote control does not have a
default temperature setting and
therefore has no default "Priority"
function.The "priority" will be attributed
automatically by the first user who
selects or memorizes (on the remote
control or on the heater’s control
panel) a temperature for subsequent
use (e.g. a shower).
Then, when the hot water is used (e.g.
for a shower), the heater's display and
additional remote control displays will
show the symbol "
".
The temperature may only be modified
using the same buttons that set it
(depending on whether the control
panel or the remote control was used).
The priority device will not have the
symbol "
".
To clear a device that is locked out with
the "
" symbol (with no hot water
running) simply:
B press and hold both the " " and
" " buttons on that device for 5
seconds.
The "Priority" function ends:
• 5 minutes after the last use of the
hot water (return to basic set up).
• 2 minutes after selecting/
memorizing the temperature if no hot
water is used immediately
afterwards.
Acquiring "priority”
Any user can acquire "priority" for
subsequent use of hot water, as
follows:
B Move the heater's main switch to the
ON position (I).
B Press and hold " " or " " to
select the desired temperature.
B Press and hold the "Program" but-
ton until the symbol "Pr" appears on
the remote control display.
B Use the hot water within two
minutes of acquiring "priority”.
i
Temperature cannot be
memorized or changed
using the heater's
control panel buttons or
a second remote control
when hot water is in use
(e.g. during a shower)
The "Priority" function
will automatically
activate to stop another
user from modifying the
temperature when hot
water is in use.
6720606990-0701_(Remote control)16Nov.fm Page 15 Friday, November 16, 2007 3:04 PM