Pioneer VSX-AX2AS-s - Manual (Page 83)

Additional information 12
83
En
USB interface
HDMI
iPod messages
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Symptom Remedy
No sound. • Make sure you have set up your computer system to output through the USB interface (see Using the USB
interface on page 54).
• Make sure your computers output level is turned up.
• Update to a more recent version of your software, try a different audio program, or try a different source.
Symptom Remedy
The HDMI indicator blinks
continuously. • Check all the points below.
No picture or sound. • This receiver is HDCP-compatible. Check that the components you are connecting are also HDCP-
compatible. If they are not, please connect them using the component, S-video or composite video jacks.
• Depending on the connected source component, it’s possible that it will not work with this receiver (even
if it is HDCP-compatible). In this case, connect using the component, S-video or composit video jacks
between source and receiver.
• If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
No picture. • Try changing the Resolution setting (in Setting the AV options on page 66).
No sound, or sound suddenly
ceases. • Check that the HDMI AV setting is set to AMP/THROUGH .
• If the component is a DVI device, use a separate connection for the audio.
• If analog video is being output over HDMI then there will be no HDMI audio output. Please use a separate
connection for the audio.
• Check the audio output settings of the source component.
Noisy or distorted picture. • Sometimes a video deck may output a noisy video signal (during scanning, for example), or the video
quality may just be poor (with some video game units, for example). The picture quality may also depend on
the settings, etc. of your display device. Switch off the video converter and reconnect the source and display
device using the same type of connection (component, S-video or composite), then start playback again.
• If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
Symptom Cause Action
Error I1 There is a problem with the signal path from the
iPod to the receiver. Switch off the receiver and reconnect the iPod to the receiver.
If this doesn’t seem to work, try resetting your iPod.
Error I2 The software version being used with the iPod
needs to be updated. Update the software being used with the iPod (software
versions prior to iPod update 2004-10-20 are not supported).
No Track There are no playable songs currently stored in
the iPod. Input some music files compatible with iPod playback.
VSX_AX4ASi.book.fm 83 ページ ２００６年６月８日 木曜日 午後１２時２３分