Pioneer DEH-6200BT - Manual (Page 20)

The unit can automatically search for a different sta-
tion with the same programming, even during preset
recall.
1 Press M.C. to turn Auto PI seek on or off.
Warning (warning tone setting)
If the front panel is not detached from the head unit
within four seconds of turning off the ignition, a warn-
ing tone sounds. You can turn off the warning tone.
1 Press M.C. to turn the warning tone on or off.
AUX (auxiliary input)
Activate this setting when using an auxiliary device
connected to this unit.
1 Press M.C. to turn auxiliary setting on or off.
USB PnP (plug and play)
This setting allows you to switch your source to USB/
USB-iPod automatically.
1 Press M.C. to turn the plug and play on or off.
! ON – When USB storage device/iPod is con-
nected, the source is automatically switched
to
USB/USB-iPod. If you disconnect your USB
storage device/iPod, this unit ’s source is
turned off.
! OFF – When USB storage device/iPod is con-
nected, the source is not switched to USB/
USB-iPod automatically. Please change the
source to
USB/USB-iPod manually.
Brightness (display brightness setting)
1 Press M.C. to display the setting mode.
2 Turn M.C. to switch the brightness setting.
High (high) —Low (low)
3 Press M.C. to confirm the selection.
SW control (rear output and subwoofer setting)
The rear speaker leads output ( Rear SP:) and RCA
output ( Preout:) of this unit can be used for full-
range speaker ( Rear SP: :Full/Preout: :Rear) or sub-
woofer ( Rear SP: :SUBW/Preout: :SUBW) connection.
If you switch to Rear SP: :SUBW, you can connect a
rear speaker lead directly to a subwoofer without
using an auxiliary amp.
1 Press M.C. to display the setting mode.
2 Press M.C. to cycle between as following:
Rear SP:/Preout: —Full (SUBW)/SUBW(Rear)
3 Turn M.C. to change the setting.
Rear SP:: Full —SUBW
Preout:: SUBW —Rear
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to
SW setting 1 (subwoofer on/off
setting) on page 18).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
DEMO (demo display setting)
1 Press M.C. to turn the demo display on or off.
! You can also turn on or off feature demo by
pressing / DISP/SCRL while this unit is
turned off. For more details, refer to Demo
mode on page 3.
Ever SCRL (scroll mode setting)
When Ever Scroll is set to ON, recorded text informa-
tion scrolls continuously in the display. Set to OFF if
you prefer the information to scroll just once.
1 Press M.C. to turn the ever scroll on or off.
PowerSave (power save)
Switching this function on enables you to reduce the
consumption of battery power.
Turning on the source is the only operation allowed
when this function is on.
! When this function is on, operations are limited
as follows:
! Disc cannot be ejected after this unit is turned
off.
! This unit’s phone function cannot be operated
after this unit is turned off.
! Demonstration is turned off.
1 Press M.C. to turn the power save on or off.
BT clear (resetting the Bluetooth wireless technology
module)
En
20
Section
02 Operating this unit