Pioneer DEH-6200BT - Manual (Page 7)

Removing the front panel to protect your unit from
theft
1 Press the detach button to release the front
panel.
2 Grab the front panel and remove.
3 Always keep the detached front panel in a protec-
tion device such as a protection case.
Re-attaching the front panel
1 Slide the front panel to the left until it clicks.
Front panel and the head unit are connected on
the left side. Make sure that the front panel has
been properly connected to the head unit.
2 Press the right side of the front panel until it is
firmly seated.
If you can
’t attach the front panel to the head unit
successfully, try again. However, forcing the front
panel into place may result in damage.
Turning the unit on
1 Press SRC/OFF to turn the unit on.
Turning the unit off
1 Press SRC/OFF and hold until the unit turns off.
Selecting a source
1 Press SRC/OFF to cycle between:
TUNER (tuner) —CD (built-in CD player)—USB
(USB)/ USB-iPod (iPod) —AUX (AUX)
Adjusting the volume
1 Turn M.C. to adjust volume.
Note
When this unit
’s blue/white lead is connected to
the vehicle
’s auto-antenna relay control terminal,
the vehicle
’s antenna extends when this unit’s
source is turned on. To retract the antenna, turn
the source off.
Using Bluetooth telephone
Important
! Since this unit is on standby to connect with
your cellular phone via Bluetooth wireless
technology, using it without the engine run-
ning can drain the battery power.
! Operations may vary depending on the kind of
cellular phone.
! Advanced operations that require attention
such as dialing numbers on the monitor,
using the phone book, etc., are prohibited
while driving. Park your vehicle in a safe place
when using these advanced operations.
Setting up for hands-free phoning
Before you can use the hands-free phoning
function you must set up the unit for use with
your cellular phone.
1 Connection
Operate the Bluetooth telephone connection
menu. Refer to Connection menu operation on
page 15.
2 Function settings
Operate the Bluetooth telephone function menu.
Refer to Phone menu operation on page 17.
Basic Operations
Making a phone call
1 Refer to Phone menu operation on page 17.
Answering an incoming call
1 When a call is received, press M.C.
! You can also perform this operation by push-
ing M.C.
Ending a call
1 Press PHONE/ /CONNECT.
Rejecting an incoming call
1 When a call is received, press PHONE/ /CON-
NECT.
Answering a call waiting
1 When a call is received, press M.C.
! You can also perform this operation by push-
ing M.C.
En
7
Section
02
Operating
this
unit
Operating this unit