Making a call by entering phone number, Setting the private mode, Pairing from this unit – Pioneer AVH-P6300BT User Manual
Page 37: Detailed instructions
Making a call by entering
phone number
Wed 28 may
1
12:45
PM
ABCDEHGHI
012345678901
01
1
2
3
4
5
6
7
8
9
*
0
#
+
C
Off
Important
Be sure to park your vehicle in a safe place and
apply the parking brake when performing this op-
eration.
1
Switch to the entering phone number
mode.
Refer to Introduction of Bluetooth telephone op-
erations on page 23.
2
Touch the number icons to input the
numbers.
# Up to 24 digits can be entered.
3
Make the call.
Refer to Introduction of Bluetooth telephone op-
erations on page 23.
4
End the call.
Refer to Introduction of Bluetooth telephone op-
erations on page 23.
Note
Entering phone number mode cannot be oper-
ated unless a Bluetooth telephone is connected
to this unit.
Setting the private mode
During a conversation, you can switch to pri-
vate mode (talk directly on your cellular
phone).
Refer to Introduction of Bluetooth telephone op-
erations on page 23.
Pairing from this unit
Connection
01: Phone1
02: Phone2
03: Phone3
04: Phone4
05: Phone5
1
Display the Bluetooth Connection
Menu.
Refer to Introduction of Bluetooth telephone op-
erations on page 23.
2
Touch Connection to select a device.
3
Start to search.
Starting to search.
While searching,
is displayed and when
available devices are found, the device names
or Bluetooth device addresses (if names can-
not be obtained) are displayed.
# If you want to switch between the device
names and Bluetooth device addresses, touch
the icon.
Switching between the device
names and Bluetooth device ad-
dresses.
# To cancel searching, touch Stop.
# If five devices are already paired,
Memory Full is displayed and pairing cannot be
performed. In such cases, delete a paired device
first. Refer to the next page.
# If no device can be found, Not Found is dis-
played. In such cases, check the status of the
Bluetooth device and search again.
4
Touch a device name to select the de-
vice you want to connect to.
While connecting,
Pairing is displayed. If the
connection is established,
Paired is displayed.
# If the connection fails, Error is displayed. In
such cases, try again from the beginning.
En
37
Section
11
Detailed
instructions
Detailed instructions