Pioneer AVH-P6300BT - Manual (Page 63)

Setting the video signal
When you connect this unit to an AV equip-
ment to this unit, select the suitable video sig-
nal setting.
! As this function is initially set to Auto, the
unit will automatically adjust the video sig-
nal setting.
However, the screen may turn black or
images may not be displayed properly
when
Auto has been selected and the re-
ception is weak. Normally, select the appro-
priate TV signal.
! About your country TV signal, consult with
your nearest Pioneer dealer.
! You can operate this function only for the
video signal input into the AV input.
1 Display the system menu.
Refer to Introduction of menu operations on
page 40.
2 Touch Video Signal Setting on the func-
tion menu.
Video Signal Setting items are displayed.
! AV – Adjusts the AV video signal
! AUX – Adjusts the AUX video signal
! Camera – Adjusts the camera video signal
! TV – Adjusts the TV video signal
3 Touch c or d to select the desired
video signal appears.
Auto
—PAL—NTSC—PAL-M—PAL-N—
SECAM
Selecting the area group
1 Select the TV source.
Refer to Basic operations of this unit on page
10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 40.
3 Touch TV Country Group on the func-
tion menu.
4 Touch c or d until the desired area
group appears.
Country1 (CCIR channel)
—Country2 (Italy
channel)
—Country3 (U.K. channel)—
Country4 (OIRT channel)
Auto EQ (auto-equalizing)
The auto-equalizer automatically measures
the car
’s interior acoustic characteristics, and
then creates an auto-equalizer curve based on
that information.
WARNING
As a loud tone (noise) may be emitted from the
speakers when measuring the car's interior
acoustic characteristics, never perform auto TA
or auto EQ while driving.
CAUTION
! Thoroughly check the conditions before per-
forming auto EQ as the speakers may be da-
maged if these functions are performed when:
— The speakers are incorrectly connected.
(For example, when a rear speaker is con-
nected as a subwoofer output.)
— A speaker is connected to a power amp de-
livering output higher than the speaker
’s
maximum input power capability.
! If the microphone is placed in an unsuitable
position the measurement tone may become
loud and measurement may take a long time,
resulting in battery drainage. Be sure to place
the microphone in the specified location.
En
63
Section
12
Menu
operations
Menu operations