Pioneer SPH-DA01 - Manual (Page 7)

Connecting your iPhone
Using the supplied iPhone cable enables you
to connect your iPhone to this product.
p Connection via a USB hub is not possible.
% Connect your iPhone.
Output cable iPhone cable
Disconnecting your iPhone
% Pull out the iPhone cable after checking
that no data is being accessed.
Startup and termination
1 Start the engine to boot up the system.
After a short pause, the splash screen comes
on for a few seconds.
2 Read the disclaimer carefully, checking
its details, and then tap [OK] if you agree
to the conditions.
p On first-time startup, a language setup
screen appears before the disclaimer. Se-
lect the language of your choice in this
screen.
3 Turn off the vehicle engine to termi-
nate the system.
Quick Start Mode
Your AppRadio features a Quick Start Mode
that puts the AppRadio into a reduced power
mode for five minutes when the vehicle igni-
tion is switched to off (ACC OFF). While in
Quick Start Mode, if you turn the ignition
switch on (ACC ON), AppRadio will immedi-
ately start up. If the unit is in Quick Start Mode
and the ignition is not switched on (ACC ON)
within five minutes, AppRadio automatically
turns off.
Demonstration images
If you do not operate this product for 30 sec-
onds, demonstration images are displayed.
When you turn the ignition switch off (ACC
OFF) and then turn it on again (ACC ON), the
demonstration images will not be displayed.
p If you reset the system, the demonstration
images will be displayed again.
Engb
7
Chapter
02
About
AppRadio
About AppRadio