Pioneer VSA-AX10Ai-S - Manual (Page 26)

Connecting your equipment 02
26
En
Plugging in the amplifier
Only plug in after you have connected all your
components to this amplifier, including the speakers.
Caution
• Handle the power cord by the plug part. Do not pull
out the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could
cause a short circuit or electric shock. Do not place
the unit, a piece of furniture, or other object on the
power cord or pinch the cord in any other way. Never
make a knot in the cord or tie it with other cables. The
power cords should be routed so that they are not
likely to be stepped on. A damaged power cord can
cause a fire or give you an electric shock. Check the
power cord once in a while. If you find it damaged,
contact the Pioneer Service Center specified on your
warranty card for a replacement.
• Do not use any power cord other than the one
supplied with this unit.
• Do not use the supplied power cord for any purpose
other than that described below.
• The amplifier should be disconnected by removing
the mains plug from the wall socket when not in
regular use, eg., when on vacation.
1 Plug the supplied power cord into the AC IN
socket on the back of the amplifier.
2 Plug the other end into a power outlet.
About the AC outlet
(Switched 100W max.)
Power supplied through this outlet is turned on and off by
the amplifier's
STANDBY/ON switch. Total electrical
power consumption of connected equipment should not
exceed 100 W (0.4 A).
Caution
• Do not connect a TV set, monitor, heater, or similar
appliance to this unit's AC outlet.
• Do not connect appliances with high power
consumption to the AC outlet in order to avoid
overheating and fire risk. This can also cause the
amplifier to malfunction.