Pioneer VSA-AX10Ai-S - Manual (Page 70)

Using other functions 08
70
En
Reducing the level of an analog
signal
The input attenuator lowers the input level of an analog
signal when it’s too strong. You can use this if you find
the that the
OVER indicator is lights often, or you can
hear distortion in the sound.
• From the remote control amplifier menu, press
INPUT ATT to switch the input attenuator on or off.
You may need to press on the Home menu ( )
first before reaching the amplifier menu screen shown
below (use the
/ (cursor left/right) soft keys to go to
the previous/next menu screen).
Note
• The attenuator isn’t available with digital sources, or
when using Stream Direct modes 2 or 3.
Adjusting the delay of a soundtrack
Some monitors have a slight delay when showing video,
so the soundtrack will be slightly out of sync with the
picture. By adding a bit of delay, you can adjust the sound
to match the presentation of the video.
1 Press OPTION repeatedly until SOUND DELAY
shows in the display.
With the remote, you may need to press on the
Home menu ( ) first before reaching the amplifier
menu screen shown below (use the / (cursor left/
right) soft keys to go to the previous/next menu screen).
2 Use the (OPTION) +/– buttons to adjust the
amount of delay.
The delay can be adjusted from 0.0–6.0 frames (in 0.1
frame steps).
3 Press ENTER to confirm.
Note
• When listening to an analog source, you can’t use
sound delay when Stream Direct is on.
• One second is equal to 30 frames of NTSC format
video, and 25 frames of PAL.
Watching video and audio sources
independently
You can listen to a sound source and select a different
video source on your TV.
• While listening to a source, press VIDEO SELECT
to select the video source you want to watch.
With the remote, you may need to press on the
Home menu ( ) first before reaching the amplifier
menu screen shown below (use the / (cursor left/
right) soft keys to go to the previous/next menu screen).
AMPLIFIER
AMPLIFIER 3/3
SB CH
MODE
INPUT
STATUS
INPUT
ATT
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
DISPLAY
DIMMER
AMPLIFIER
TV
CONT
PHONES SP SYSTEM
A/B
SIGNAL
SELECT VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO VIDEO
VIDEO INPUT
AUDIO L R
MIDNIGHT LOUDNESS OPTION TONE DIGITAL NR INPUT ATT SELECT
CH LEVEL ACOUSTIC
CAL.
AMPLIFIER
AMPLIFIER 2/3
AMPLIFIER
TV
CONT
MIDNIGHT DIGITAL NR
TONE LOUDNESS
OPTION + –
CH LEVEL + –
PHONES SP SYSTEM
A/B
SIGNAL
SELECT VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO VIDEO
VIDEO INPUT
AUDIO L R
MIDNIGHT LOUDNESS OPTION TONE DIGITAL NR INPUT ATT SELECT
CH LEVEL ACOUSTIC
CAL.
AMPLIFIER