Pioneer VSA-AX10Ai-S - Manual (Page 72)

Using other functions 08
72
En
Dimming the display
You can choose between four brightness for the front
panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
• From the remote control amplifier menu, press
DISPLAY DIMMER repeatedly to change the
brightness of the front panel display.
You may need to press on the Home menu ( )
first before reaching the amplifier menu screen shown
below (use the
/ (cursor left/right) soft keys to go to
the previous/next menu screen).
Switching the speaker impedance
• Default setting: Speaker 6Ω Ω Ω Ω
You can use speakers with a nominal impedance
between 4–16Ω but if you are using speakers with an
impedance of less than 6Ω, you must change the
impedance setting below.
• With the amplifier in standby, press STANDBY/
ON while holding down the OPTION – button.
Each time you do this, you switch between the
impedance settings:
• Speaker 4Ω Ω Ω Ω – Use this setting if your speakers are
rated lower than 6Ω (down to 4Ω).
• Speaker 6Ω Ω Ω Ω – Use this setting if your speakers are
rated 6Ω–16Ω.
Note
• If you select Speaker 4Ω Ω Ω Ω above, the Stream Direct
setting is fixed at SD:1 NORMAL (see Using the
Stream Direct mode on page 43).
AMPLIFIER
AMPLIFIER 3/3
SB CH
MODE
INPUT
STATUS
INPUT
ATT
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
DISPLAY
DIMMER
RECEIVER
TV
CONT
STANDBY/ON
OFF ON
STANDBY
DVD/LD TV/DVD SAT VIDEO
VIDEO AUDIO
DVR/VCR1 VCR2 VCR3 CD TUNER P CD-R/ TAPE1/MD
INPUT SELECTOR
PHONES SP SYSTEM
A/B
SIGNAL
SELECT VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO VIDEO
VIDEO INPUT
AUDIO L R
MIDNIGHT LOUDNESS OPTION TONE DIGITAL NR INPUT ATT SELECT
CH LEVEL ACOUSTIC
CAL.