Pioneer PDA-V100HD - Manual (Page 29)

Additional information 12
29
En
English
Independent 2 mode
During setting mode
For about five seconds after pressing the remote control unit buttons to enter a setting mode, the indicators will
appear as noted below:
When the setting mode ends, the unit will return to power ON mode for ordinary operation.
(*) Factory default settings
When setting HDMI output resolution (when RESOLUTION button is pressed.)
When setting colour system for analog signals (when COLOUR SYSTEM button is pressed.)
Condition
Power ON
indicator
STANDBY
indicator
HDMI CONTROL
indicators
INPUT indicators
Blue
illumination
Remarks
Power ON Lights blue Off All off Only currently selected
input lights
Lights blue
Power ON
(setting mode) Depends on relevant
settings
Flashes blue (See chart “During
setting mode”)
STANDBY Off Lights red All off Off
Item INPUT indicators Blue illumination Indicator status
Auto (*) 1 2 3 4 5 6 Flashes blue • When power ON.
• When currently selected input is INPUT 2,
INPUT 3*, or INPUT 5.
* When setting the type of component
connected to SCART connector.
480p/576p 1 2 3 4 5 6
720p 1 2 3 4 5 6
1080i 1 2 3 4 5 6
Item INPUT indicators Blue illumination Indicator status
Auto (*) 1 2 3 4 5 6 Flashes blue • When power ON.
• When currently selected input is INPUT 3*,
INPUT 5.
* When setting the type of component
connected to SCART connector.
PAL 1 2 3 4 5 6
SECAM 1 2 3 4 5 6
NTSC 1 2 3 4 5 6
4.43 NTSC 1 2 3 4 5 6
PAL 60 1 2 3 4 5 6